LSL RiseUp Riser Kit, TRIUMPH, 25mm, Ø1 inch

Product Details

LSL RiseUp Riser Kit, for Triumph, 25 mm rise, for 1 inch handlebar, black

General Description

LSL Clamp Risers (identification D25T) for inch handlebar
Rise of the handlebar position by 25 mm

Material: Aluminium
Surface treatment: Anodised
Mounting: Between the original clamp
Offset: + 25 mm
Dimensions: 1 inch clamping

Our model-specific clamp risers are mounted at the original mounting points. For models with standard rubber mounts, these are retained. Depending on the model, the handlebar position changes from -50mm to +30mm; the value for your motorcycle is given under offset.

ATTENTION IMPORTANT NOTE: Please check before conversion whether the vehicle intended for conversion is listed in the attached ABE! For each vehicle, there are different requirements and conditions that allow a conversion of the clamp risers. The model assignments of the LSL clamp risers listed in the ABE are tested for use with the vehicle's standard handlebar. The additional use of an LSL accessory handlebar is possible but, due to a different shape of the handlebar, may require additional modifications to the vehicle (longer lines or cables). Raising the original handlebar can also lead to additional vehicle modifications. Check whether the following conditions apply to your vehicle (-see ABE):
- Use permitted when using a compensating shim for the triple clamp
- Use permitted with 20 mm longer brake line
- Use permitted with 30 mm longer brake line
- Use permitted with LSL instrument holder

Non-compliance will invalidate the vehicle's operating permit!

The following items are suitable for this product: Inch handlebar