LSL MANTIS-RS for Husqvarna 701 Enduro, Supermoto, 2016-2020, with Number Plate Light

Product details

LSL MANTIS-RS number plate holder with illumination for
Husqvarna
701 Enduro, Supermoto, Type HUSQVARNA701, Model Year 2016-2020

General description

LSL MANTIS-RS Number Plate Holder
Making good bikes perfect. Following this motto, LSL has developed the LSL MANTIS-RS number plate holder.
It perfectly fits your motorcycle and, with its sporty design, underlines the lines of your bike.
And, as usual from LSL, everything has been considered.
The model-specific attachment, bracket of the LSL MANTIS-RS allows for replacement without further drilling or cutting on the vehicle.
The design perfectly adapts to the rear of your motorcycle and utilises the original mounting points of the vehicle.
To prevent cable damage, sharp-edged cable entries are protected with rubber grommets.
The number plate panel is made from 2 mm thick steel sheet, laser-cut, edged, and weather-resistant black powder-coated.
The number plate panel is secured in the correct position by an additional locking screw.
The width-adjustable flasher bracket of the LSL MANTIS-RS are suitable for all types of accessory flasher light, turn signal. This adjustability allows you to find the perfect position for your flasher light, turn signal. Adapting to various EU number plates is therefore no problem. The mounting holes for the flasher light, turn signal have a diameter of 8 mm and are slotted sideways. This allows for flasher light, turn signal installation without disconnecting the wiring harness.
The slide for mounting the reflector is also individually adjustable. Adapting to the different versions of EU number plates is therefore no problem.
The two supplied rubber washers serve to reduce vibration when screwing on the number plate. An additional rubber buffer supports the number plate from below.
Details:
• model-specific attachment, bracket
• infinitely adjustable flasher bracket
• slotted flasher light, turn signal mounting for easy installation without cable disconnection
• infinitely adjustable reflector, E-marked
• suitable for European number plates
• infinitely adjustable tilt angle
• additional screw for optimal position security
• easy fixing without further steps (e.g. drilling)
• easy number plate mounting using slotted holes
The LSL MANTIS-RS includes:
• Model-specific attachment, bracket with mounting parts
• LSL MANTIS-RS number plate panel
• Adjustable flasher light, turn signal-attachment, bracket
• E-marked reflector with adjustable bracket
• Installation instructions
Note:
If side reflectors are mounted on your original number plate holder, they must be re-attached in a suitable position or replaced with new ones.
Tip:
If you haven't found a model-specific number plate holder for your vehicle, the universal number plate holders from LSL, available in many different designs, are certainly a good alternative.