LSL handlebar-Rise-Up Ø22.2

Product details

LSL handlebar-Rise-Up 25 mm, silver

General description

handlebar-Rise-Up Ø22.2
handlebar risers RiseUp in black or silver, for 7/8 inch handlebar (Ø22.2 mm). The handlebar position is moved upwards and 17 mm closer to the rider. This gives you a more upright and relaxed seating position, with ABE, set.

LSL handlebar Risers RiseUp for 7/8 inch handlebar

Clamping blocks that are installed into the standard clamps. By using the milled spacer blocks, the handlebar position is moved upwards and closer to the rider. This results in a significantly more upright and relaxed seating position.

- Material: Aluminium
- Material treatment: CNC-milled, anodised
- Offset: 25 mm or 35 mm up, 17 mm closer to the rider
- Mounting: For all motorcycles with 32-35 mm hole spacing and 7/8 inch handlebar (Ø22.2mm)
- Available in black or silver
- With ABE* for many models

Scope of delivery: 1 set, iincluding mounting screws and component certificate.

IMPORTANT NOTE:
Before conversion, please check whether the vehicle intended for conversion is listed in the attached ABE!
For each vehicle, there are different prerequisites and conditions that allow for the conversion of the clamping blocks.

*The model assignments of the LSL clamping blocks listed in the ABE are tested for use with the vehicle's standard handlebar.
Additional use of an LSL accessory handlebar is possible, but due to a different handlebar shape, it may require additional changes to the vehicle (longer lines or cables).
Raising the original handlebar can also lead to additional changes to the vehicle.

Check if the following conditions apply to your vehicle (see ABE):
- Use permitted when using a compensating shim for the triple clamp
- use permitted with 20 mm longer brake line
- use permitted with 30 mm longer brake line
- use permitted with LSL instrument holder

Failure to comply will invalidate the vehicle's operating licence!

The conversion should only be carried out by trained specialist personnel.