LSL Handlebar Clamps for Yamaha BT1100 Bulldog, 57 mm Lower, Black

Product Details

LSL handlebar clamps for Yamaha BT1100 Bulldog, 57 mm lower than original, black

General Description

Handlebar clamps (identification KM3) silver or black for standard 22.2mm handlebar
suitable for the following vehicle:
Yamaha
BT 1100 Bulldog
Material: Aluminium
Material treatment: anodised
Offset: - 57 mm or - 45 mm
Mounting: at original mounting points
Dimensions: 22.2 mm clamping
Our model-specific handlebar clamps are mounted at the original mounting points. For models with standard rubber mounting, this is retained. Depending on the model, the handlebar position changes from -30mm to +25mm; the value for your motorcycle is specified under offset.
ATTENTION IMPORTANT NOTE: Please check before conversion whether the vehicle intended for conversion is listed in the attached ABE!
Different requirements and conditions apply to each vehicle that permit the conversion of the handlebar clamps.
The model assignments of LSL handlebar clamps listed in the ABE are tested for use with the vehicle's standard handlebar.
The additional use of an LSL accessory handlebar is possible but may require additional changes to the vehicle (longer lines or cables) due to a different shape of the handlebar.
Even raising the original handlebar can lead to additional changes to the vehicle.
Check if the following conditions apply to your vehicle (see ABE):
- Use permitted with a compensating shim for the triple clamp
- Use permitted with 20 mm longer brake line
- Use permitted with 30 mm longer brake line
- Use permitted with LSL instrument holder
Failure to comply will invalidate the vehicle's operating permit!
The following items match this product: 22.2mm-handlebar