LSL Handlebar Clamp Kit for Triumph Bonneville T120, for 1 inch-handlebar, silver

Product details

LSL Handlebar Clamp Kit for Triumph Bonneville T120, for 1 inch-handlebar, silver

General description

Handlebar clamps (identification KC45) for inch handlebar
suitable for the following vehicles:
Triumph
Bonneville T 120
Material: Aluminium
Material treatment: anodised
Mounting: between the original clamp
Offset: + 5 mm higher, 10 mm further to the front.
ATTENTION: When fitting LSL handlebars, the original heated grips will be omitted!
Dimensions: 1 inch clamp

Our model-specific handlebar clamps are mounted at the original attachment points.
For models with standard rubber mounts, these are retained. Depending on the model, the handlebar position changes from -50mm to +30mm; the value for your motorcycle is indicated under offset.
ATTENTION IMPORTANT NOTE: Please check before conversion whether the vehicle intended for conversion is listed in the attached ABE!
For each vehicle, there are different requirements and conditions that allow a conversion of the handlebar clamps.
The model assignments of the LSL handlebar clamps listed in the ABE are tested for use with the vehicle's standard handlebar.
The additional use of an LSL accessory handlebar is possible, but due to a different shape of the handlebar, it may necessitate additional changes to the vehicle (longer lines or cables).
Increasing the original handlebar can also lead to additional changes to the vehicle.
Check if the following conditions apply to your vehicle (see ABE):
- Permitted for use with a compensating pad for the triple clamp
- Permitted for use with a 20 mm longer brake line
- Permitted for use with a 30 mm longer brake line
- Permitted for use with LSL instrument holder
Failure to comply will invalidate the vehicle's operating permit!
The following items match this product: Inch handlebar