LSL Clamp Block Kit 28.6 mm for Triumph Tiger 1050, -2011, silver

Product details

LSL Clamp Block Kit 28.6 mm for Triumph Tiger 1050, model year -2011, silver

General description

X-Bar clamp blocks (identification KM45) silver for 28.6 mm handlebar
suitable for the following vehicle:
Triumph
Tiger 1050 up to model year 11
Material: Aluminium
Material treatment: anodised
Mounting: + 11 mm
Dimensions: 28.6 mm clamping
Our model-specific X-Bar clamp blocks are mounted at the original mounting points. This allows an X-Bar handlebar mount, fit, assemble on many models with original 22.2mm-handlebar.
For models with standard rubber mounting, this is retained. Depending on the model, the handlebar position changes from -50mm to +30mm; the value for your motorcycle is specified under offset.
ATTENTION IMPORTANT NOTE: Please check before conversion whether the vehicle intended for conversion is listed in the attached ABE!
For each vehicle, there are different prerequisites and conditions that allow for the conversion of the clamp blocks.
The model assignments of the LSL clamp blocks listed in the ABE are tested for use with the vehicle's standard handlebars.
The additional use of an LSL accessory handlebar is possible, but due to a different shape of the handlebars, it may necessitate additional changes to the vehicle (longer lines or cables).
Raising the original handlebars can also lead to additional changes to the vehicle.
Check if the following conditions apply to your vehicle (see ABE):
- Use permitted with the use of a compensating shim for the triple clamp
- Use permitted with 20 mm longer brake line
- Use permitted with 30 mm longer brake line
- Use permitted with LSL instrument holder
Failure to comply will invalidate the vehicle's operating permit!
The following items are suitable for this product: 28.6 mm-handlebar X-Bar